Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REPLACE THE FRONT FAN
1. Position the fan on the mounting bracket.
When correctly positioned, the metal grille on the fan should face away from the bracket and
the fan cable should be able to reach its connector on the motherboard.
2. Replace the four plastic rivets that secure the fan to the mounting bracket (see
page
109).
Hold the fan firmly against the mounting bracket, and push each rivet all the way through the
mounting hole until it snaps into locked position. Make sure that the fan is tightly secured to
the mounting bracket.
N
:
If you are replacing the old fan with a new one and you damaged the original rivets
OTE
while removing the old fan, use the rivets provided in the bag labeled "FRONT FAN."
This bag of rivets accompanies the spare fan kit.
3. Insert the fan assembly into the space between the board guide and the chassis
(see
Figure 37 on page
4. Secure the fan assembly to the chassis.
Fit the three tabs at the bottom of the mounting bracket into the three slots in the chassis
(see
Figure 37 on page
mounting bracket lock into place.
5. Connect the 3-pin fan connector to the left three pins of connector J52 on the motherboard
(see
Figure 17 on page 58
6. Reassemble the imagePRESS Server and verify its functionality (see
108).
108). Press the assembly flat against the chassis until the latches on the
and
Figure 26 on page
76).
page
130).
110
Figure 38 on
Advertisement
Table of Contents
