Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
3. Power on the imagePRESS Server using the power button on the front panel. Allow the system
to start up and reach Idle.
At this point the imagePRESS Server is in Service Mode, so you can make sure the new
motherboard solves the problem you are trying to troubleshoot. Service Mode is not indicated
on the monitor or the imagePRESS Server Control Panel.
4. Make sure that the imagePRESS Server is connected to the copier (see
imagePRESS Server Test Page (see
5. Ask the network administrator to connect the imagePRESS Server to the network (see
page
40) and download a print job over the network (see Configuration and Setup on the
User Documentation CD).
If the problem that you are troubleshooting persists, or if you are unable to perform steps 4
and 5 above while in Service Mode, the new motherboard has not solved the problem that
you are troubleshooting. If this is the case, do not transfer options to the motherboard (described
on
page
90), and do not attempt any other troubleshooting procedures yet (such as reinstalling
system software or replacing the HDD). Reinstall the old motherboard and return the new
motherboard with the unused single-use dongle to inventory. You may then perform
additional service and troubleshooting procedures.
If the imagePRESS Server is able to print a Test Page and a print job sent over the network,
you may conclude that the new motherboard solves the problem that you are troubleshooting.
You may now transfer options to the new motherboard (see
page
49).
page
36) and print the
page
90).
89
Advertisement
Table of Contents
