Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
N
:
When installing DIMMs, note the following:
OTE
• Only the odd-numbered sockets in
in even-numbered sockets J12, J10, J8, J6, J4, or J2.
• The DIMM configurations installed in socket Set 0 and Set 1 must be identical. That is,
each set must contain the same number of DIMMs and the total memory capacity
installed in each set must be the same.
• DIMMs must first be installed in the A-position sockets, then the B-position sockets, and
finally the C-position sockets of each set. Higher-capacity DIMMs should be installed first
in the A-position sockets, with the other DIMMs following in descending order of
capacity. For example:
– In a two-DIMM configuration, use the A-position (J11 and J5) sockets.
– In a four-DIMM configuration, use the A-position (J11 and J5) and B-position (J9 and
J3) sockets.
– In a six-DIMM configuration, use the A-position (J11 and J5), B-position (J9 and J3),
and C-position (J7 and J1) sockets.
Figure 32 on page 99
are used. Do not install DIMMs
100
Advertisement
Table of Contents
