Servicing Hdds Inside The Security Enclosure - Canon imagePRESS A3200 Installation And Service Manual

S P
ERVICE ROCEDURES
6. Connect the SATA power cable connectors to all three HDDs.
Always connect power to the SATA power connectors on the HDDs. Do not use the
N :
OTE
PATA power connectors, if they are present on the HDDs.
7. Reassemble the imagePRESS Server (see
8. Connect the cables that you removed from the back of the imagePRESS Server.
9. If you replaced a HDD with a new HDD, install system software and user software
(see page 132).
If a startup error appears on the monitor when you power on the imagePRESS Server,
check the connections.
10. Verify imagePRESS Server functionality (see

Servicing HDDs inside the security Enclosure

This section describes how to replace HDDs installed inside the Enclosure that ships with the
HDD Security Option.
T
O INSTALL A REPLACEMENT
Be sure to perform all the steps of this procedure exactly as described. If you fail to perform all
of the steps of this procedure, system problems may result.
1. Remove the old HDD from the Enclosure, and install the replacement HDD inside the
Enclosure.
For detailed instructions, see the documentation that accompanies the HDD Security
Option.
2. Install the Removable HDD Firmware Update using the External RHDD Firmware Update CD
and the documentation that accompanies the HDD Security Option.
3. Power off the Enclosure using the Enclosure's main power button.
4. Wait one minute.
5. Power on the Enclosure using the Enclosure's main power button.
6. Install system software (see
If a startup error appears on the monitor when you power on the imagePRESS Server, check
the connections.
7. Verify imagePRESS Server functionality (see
page
HDD E
INSIDE THE SECURITY
page 132).
130).
page 131).
NCLOSURE
page 131).
123