Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
PRESS S
O OPEN THE IMAGE
1. Shut down the imagePRESS Server (see
2. Wait 10 seconds after the imagePRESS Server powers off, and then remove all external cables
from the back of the system.
3. Remove all external panels necessary to access the component that you need to service.
At the minimum, you must remove the left panel to service the component. You may
also need to remove other panels, depending on the component that you need to access.
For guidelines on which panels to remove, see the service procedure for the given component.
When removing multiple panels from the imagePRESS Server, use the
N
:
OTE
following order:
• Left panel (see
• Right panel (see
• Front panel (see
• Top panel (see
Reverse the listed order when replacing panels.
N
:
OTE
4. Place the imagePRESS Server on a flat surface. Attach an ESD wrist strap before handling
internal parts (see
All internal components that you remove must be placed on a grounded, antistatic surface
(see
page
19).
5. Carefully position the imagePRESS Server so that it is resting on its side and the internal
components are facing up.
ERVER
page
page
62)
page
62)
page
63)
page
65)
"Precautions" on page
17).
59).
61
Advertisement
Table of Contents
