Table of Contents
Advertisement
S
ERVICE
T
O REMOVE THE USER INTERFACE BOARD
1. Shut down and open the imagePRESS Server (see
To access the UIB, you must remove the left, right, front, and top panels from the chassis.
N
OTE
cable out of the chassis when removing the top panel.
2. Turn the top panel over to expose its underside and place it on a padded surface.
3. Detach the UIB cable from the connector on the back of the UIB.
Detach the UIB cable by grasping the cable connector. Avoid pulling on the cable itself.
4. Remove the four screws that secure the UIB to the underside of the top panel
(see
5. Remove the UIB from the top panel. Be sure to remove the plastic lens that covers the
display window of the UIB.
Screw (1 of 4)
F
IGURE
6. If you are removing the UIB to replace it with a new board, remove the buttons from the old
UIB.
Carefully pull the buttons out of the anchoring holes on the UIB (see
Take care not to damage the pointed tabs on the back of each button set.
7. Place the board in an antistatic bag.
P
ROCEDURES
:
Be sure to detach the UIB cable from its connector on the motherboard, and pull the
Figure
24).
24:
Removing/replacing the user interface board
page
59).
UIB
Top panel
Figure 25 on page
72
73).
Advertisement
Table of Contents
