Table of Contents
Advertisement
S
ERVICE
Accessing internal components
This section describes how to shut down and open the imagePRESS Server. Always use the
following procedures when opening the imagePRESS Server for inspection or service.
Shutting down the system
If the imagePRESS Server is powered on, you must shut down the system before you access
the internal components.
N
:
When the imagePRESS Server is powered off, network access to the copier is
OTE
interrupted. Always obtain permission from the network administrator before you take the
imagePRESS Server off the network.
T
O SHUT DOWN THE IMAGE
1. Ensure that the imagePRESS Server is not receiving, processing, or printing any files.
If the system has just finished processing, wait at least 5 seconds after the system reaches Idle
before beginning the shutdown procedure.
N
:
Notify the network administrator before you remove the imagePRESS Server from
OTE
the network.
2. Press the Menu button on the imagePRESS Server Control Panel.
3. Press the line selection button for Shut Down System.
Allow the system to shut down completely.
4. If desired, move the power switch on the back of the imagePRESS Server to the OFF (O)
position for maximum energy savings.
5. After powering off, wait at least 10 seconds before you begin servicing the
imagePRESS Server.
P
ROCEDURES
PRESS S
ERVER
59
Advertisement
Table of Contents
