Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
8. Wait for Idle to display on FieryBar.
If the imagePRESS Server is not connected to the copier, "Check power and cable" displays
instead.
9. Shut down the imagePRESS Server and reattach any dongle(s) (for example, for SeeQuence
Suite) or USB device that you may have removed previously.
Viewing dongle and server information
This section describes how to view information about the dongle and the server.
N
:
This section is only applicable if your new motherboard kit contains the Fiery Options
OTE
Utility DVD.
• Selecting
Dongle Info
options allows you to determine the number of uses remaining on the dongle and the
option or function that the dongle enables.
• Selecting
Server Info
options allows you to determine the imagePRESS Server BIOS version, motherboard
MAC address, and options currently enabled on the system. This information is useful
when you want to verify the state of the system before and after you expend the dongle.
T
O VIEW DONGLE OR SERVER INFORMATION
1. Make sure that the imagePRESS Server is off, and then attach the one-time use dongle to a
USB port on the imagePRESS Server.
2. Power on the imagePRESS Server and immediately insert the Fiery Options Utility DVD into
the DVD drive in time for the imagePRESS Server to boot from it.
3. When the first screen displays, select OK on the Control Panel or the monitor.
(For more information about choosing an interface when the first screen displays, see
on page
91).
(or
View Dongle Information
(or
View Server Information
on the monitor) before transferring
on the monitor) after transferring
93
step 4
Advertisement
Table of Contents
