Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REMOVE THE COPIER INTERFACE BOARD
1. Shut down the imagePRESS Server, remove all cables from the back, and then open the
system (see
page
In order to access the copier interface board, you must remove the left panel. Make sure that
you have removed the copier interface cables from the back of the imagePRESS Server.
2. Remove the bracket cover plate from the back panel (see
You must remove the bracket cover plate in order to access the bracket screw for the copier
interface board.
3. Remove and set aside the bracket screw that attaches the board mounting bracket to the back
panel.
4. Remove the copier interface board from its motherboard PCI connector.
Grasp the board at the front and back edge and gently pull the board straight out of its
connector on the motherboard. Remove the board from the chassis.
When removing the board, be careful not to damage or disconnect any motherboard cables
that are installed nearby.
Place the removed board in an antistatic bag.
T
O REPLACE THE COPIER INTERFACE BOARD
1. Install the copier interface board in the PCI-E1 x8 connector on the motherboard.
The copier interface board connector is keyed to fit only one way.
When installing the board, be careful not to disturb any motherboard cables that are installed
nearby.
2. Replace the bracket screw to the mounting bracket in the back panel slot.
3. Replace the bracket cover plate to the back panel (see
4. Reassemble the imagePRESS Server and verify its functionality (see
59).
Figure 13 on page
54).
Figure 13 on page
54).
page
130).
68
Advertisement
Table of Contents
