Table of Contents
Advertisement
I
NSTALLATION
Connecting power and the dongle
Use the following procedure to connect power and the dongle to the imagePRESS Server.
T
O CONNECT POWER AND THE DONGLE
1. Connect the recessed end of the imagePRESS Server power cable to the power connector on
the back of the imagePRESS Server, as shown in
of the cable to a wall outlet.
Be sure to use the appropriate power cable for your regional outlet type.
2. To use the SeeQuence Suite features of Command WorkStation on the imagePRESS Server,
install the SeeQuence Suite dongle directly on one of the imagePRESS Server USB ports
(see
Figure 6 on page
The SeeQuence Suite dongle is attached to a keychain labeled "SeeQuence Suite." To use
SeeQuence Suite on a client workstation instead of the imagePRESS Server, install the dongle
on the client workstation.
N
:
The dongle is required to use SeeQuence Suite in its fully licensed mode. If the dongle
OTE
is not installed or is removed during a work session, SeeQuence Suite will be available in
Demo mode only—that is, documents can be imposed and saved in .dbp format, but all
printed output will display a "DEMO" watermark. To remove the "DEMO" watermark,
install the dongle, and then reopen and save the document in the licensed mode of SeeQuence
Suite.
Connecting to the copier
Use the following procedure to connect the imagePRESS Server to the copier.
T
O CONNECT TO THE COPIER
1. Shut down and power off the copier (for instructions, see the documentation that
accompanies the copier).
2. If needed, shut down the imagePRESS Server (see
3. Locate the two imagePRESS Server copier interface cables, and identify the keyed and
unkeyed connector ends on each cable.
Each cable has one keyed connector and one unkeyed connector:
35).
Figure 6 on page
35. Connect the other end
page
51).
36
Advertisement
Table of Contents
