Siemens NXPLUS C Installation And Operating Instructions Manual page 82
Medium-voltage switchgear/wind fixed mounted circuit-breaker switchgear up to 36 kv, extendable
Hide thumbs
Also See for NXPLUS C:
- Installation and operating instructions manual (293 pages) ,
- Installation and operating instructions manual (266 pages)
Table of Contents
Advertisement
Installation
Mounting the new
partition
Partition plate of
switchgear rear wall
82/172
Bolt the new partition together with the threaded bolts on the vessel roof using the 3
previously removed nut-and-washer assemblies M8. Tightening torque: 30 Nm
Fig. 66:
New partition mounted
If the voltage transformers are installed in the right end panel, an additional partition plate
must be mounted on the switchgear rear wall.
Bolt partition plate
and 2 contact washers.
Fig. 67:
Bolting the partition plate together with the switchgear rear wall
Revision 05 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C Wind • 802-9074.9
Partition plate of
switchgear rear wall
together with the switchgear rear wall using 2 Torx screws M5x10
Advertisement
Table of Contents
