Siemens NXPLUS C Installation And Operating Instructions Manual page 103

802-9074.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C Wind • Revision 05
Connect the cable shield and the earthing of the plug housing to the cable bracket.

Hang the cable compartment cover in and fit the two or four fixing screws again.

ATTENTION!
To guarantee safe earthing of the cable compartment cover, observe the following:
Do always use the Torx screws M5 with cutting ring supplied to fasten and earth the cable

compartment cover.
Fix the cable compartment cover at the lower edge. Depending on the panel width, two or

four Torx screws with cutting ring are required for this. Tightening torque: 7 Nm.
Fig. 92: Earthing the cable compartment cover with
Torx screw with cutting ring
Installation
Torx screw with
cutting ring
103/172