Siemens NXPLUS C Installation And Operating Instructions Manual page 71

802-9074.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C Wind • Revision 05
Fig. 58: Bolted joints for panel interconnection
Mount the panel link

nut-and-washer assemblies
Fig. 59: Panel link, mounted
Check the reference dimension K1 between the bushings (see page 72, "Assembling the

busbars").
Remove cable compartment covers and operating mechanism covers.

ATTENTION!
After removal, the cable compartment and operating mechanism covers must be mounted on
the same panels again.
Write the corresponding panels numbers on all covers after removal.

Approach all other panels one after the other, align them and bolt the alignment brackets

and the frames together.
between the two panels with two bolts M8x45 (saucer-head) and
.
Felt strips, pre-assembled at the factory
Screw M5x16, thread-ridging
Bolt M8x20, with nut-and-washer assembly
Panel link
Bolt M8x45 and nut-and washer assembly
Installation
71/172