Siemens NXPLUS C Installation And Operating Instructions Manual page 87

Mounting the
busbar covers
802-9074.9 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C Wind • Revision 05
Mount the 3 voltage transformers

each. Tightening torque: 20 Nm.
Fig. 75: Bolted joints of voltage transformers
3D washer
Bolt-and-washer assembly M8
Establish secondary connections to the low-voltage compartment with a plug connector.

Connect the earthing cable of the adapter.

ATTENTION!
After removal of the voltage transformers, cover the busbars again in a surge-proof way.
To do this, always keep the cap and the screw-type cone in the storage box.

Refit the busbar covers; first mount the left-hand

the reinforcing plate
Fig. 76: Busbar cover (view from the rear)
with 4 bolt-and-washer assemblies and 3D washers
.
and right-hand busbar covers, then
Right-hand busbar cover
Left-hand busbar cover
Reinforcing plate
Installation
87/172