Siemens NXPLUS C Installation And Operating Instructions Manual page 106

Installation
Principle of installation
Installation of cable-type
current transformers
106/172
Fig. 96: Cable connection with cable-type current transformers type 4MC7032
Cable plug
High-voltage cable
Transformer mounting plate
Earthing point
Cable-type current transformer
Cable shield
Remove the cable compartment cover.

Take the supplied cable-type current transformers

Push the cable-type current transformers

Place the cable-type current transformers

Mount the cable plugs

Position the pre-assembled transformer mounting plate

way that all 3 cable-type current transformers can be mounted.
Bolt the cable-type current transformer

2 supports , saucer-head bolts
Lead the cable shield

at the earthing point
Swing the high-voltage cables

and connect the cable plugs
plugs").
Mount the cable compartment cover.

Revision 05 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C Wind • 802-9074.9
Cable clamp
3D washer A10.5 (2x)
Nut-and-washer assembly M8 (2x)
Saucer-head bolt M8x20 (2x)
Current transformer holder (2x)
Felt strip (2x)
on the high-voltage cables.
into the supports
according to the manufacturer's instructions.
onto the transformer mounting plate
, 3D washers
back through the cable-type current transformer
.
in together with the cable-type current transformers
to the cable feeder (see page 99, "Connecting cable T-
out of the cable compartment.
, and bolt tight.
at the cable bracket in such a
and nut-and-washer assemblies
, and bolt tight
with the
.
,