Siemens NXPLUS C Installation And Operating Instructions Manual page 64

Installation
Removing from the
wooden pallets
64/172
If the panels are equipped with an interlock for the cable compartment cover, the panels must
be earthed to remove the cable compartment cover.
Remove PE foil.

Undo the bolted joint of the cable compartment cover at the front. Depending on the panel

width, there are two or four self-tapping screws.
Fig. 46: Bolted joints of cable compartment cover
If cable compartment cover is interlocked: Push the locking device lever

keep it in this position.
Fig. 47: Front plate with mimic diagram on the circuit-
breaker panel
Revision 05 • INSTALLATION AND OPERATING INSTRUCTIONS • NXPLUS C Wind • 802-9074.9
450 mm: Disconnector panel and ring-
main panel
600 mm: Circuit-breaker panel
upwards and
"Feeder earthed" locking device