Introduction; Preface; Arrangement Of The Documentation - JUMO IMAGO F3000 Operating Instructions Manual

1.1

Preface

Version
H
Warranty
Technical
data
Electrostatic
discharge
1.2

Arrangement of the documentation

Operating
Instructions
B 70.0101
B
Expanding /
retrofitting
B 70.0101.5.1
IMAGO F3000 / 10.01
These instructions are valid for the software version: 152.00.19
The version can be called up under MENU
Instrument data
If any difficulties should arise during commissioning, please do not
make any unauthorized manipulations to the instrument. This could
endanger your rights under the instrument warranty. In such a
case, please contact your local representative or the main factory.
Technical data can be found on the Internet at: www.jumo.net
Products Electronic controllers
E
When returning instrument modules, assemblies or components,
the rules of EN 100 015 "Protection of electrostatically sensitive
components" must be observed. Use only the appropriate ESD
packaging for transport. Please note that we cannot accept any
liability for damage caused by ESD (electrostatic discharge).
These operating instructions are addressed to equipment manufacturers
(OEMs) who have had appropriate professional training. In addition to installa-
tion and electrical connection, they also include all the information required for
commissioning the instrument and setting its parameters.
Please read these operating instructions before commissioning the
equipment. Keep the operating instructions in a place that is
accessible to all users at all times.
Please help us to improve these instructions where necessary.
Phone: +49 661 6003 - 0
Fax: +49 661 6003 - 607
These instructions will be included in the package if accessory modules are
ordered at a later date.
They contain information on installing the modules and safety procedures for
internal operations within the equipment.

1 Introduction

Configuration
Programmers JUMO Imago F3000
User data
5