Table of Contents
Advertisement
Access
authorization
H
Device list
Device
assistant
IMAGO F3000 / 10.01
The range of functions that is available in the setup program can be restricted
by applying a "Specialist" password.
"Specialist" access is extended to cover the following functions:
- Instrument calibration (analog inputs and outputs)
- Test functions
- Undocumented parameters (additional functions)
- Definition of system texts
"Specialist" access can be protected by the use of a password.
File
Password
If no password is defined, then "Specialist" access will be
available without restriction.
If a password has been defined, then "Maintenance" access only
provides access to the setup program.
For communication with one or more instruments, the PC interface has to be
configured and entered in a device list.
Data transfer
Establish connection (F2)
The settings for the device addresses and interface parameters must match
those for the instrument (= device).
Pressing the Save button stores the settings permanently (also for later pro-
gram calls).
Communication with the instrument can be protected by a password. The
password is defined in the instrument.
Whenever a new configuration file is created, the hardware configuration of the
attached instrument must be transmitted to the setup program. The entry op-
tions for doing this are as follows:
Edit
Hardware
User-defined setting:
The assignments of the slots are selected manually, through pull-down menus.
Entry of the type code:
The hardware configuration is defined by entering the type code.
Automatic detection:
The hardware configuration is read out from the instrument. To do this, the in-
strument must be connected and the interface must be configured.
Factory setting:
The hardware setting is defined as the default setting for the standard version
of the instrument (see data sheet).
7 Setup Program
57
Advertisement
Table of Contents
