Stop Program; Program End Signal - JUMO IMAGO F3000 Operating Instructions Manual

Process controller for the meat processing industry

Hide thumbs Also See for IMAGO F3000:

Table of Contents

Alter setpoint

End

6.6

Stop program

6.7

IMAGO F3000 / 10.01

h Press the

A screen appears with one process step, where setpoints can be tempora-

rily altered.

h Confirm with Enter

h Press Exit to activate the new setpoint

h Press the

The hand symbol at bottom right disappears.

The instrument returns to the basic status.

All programs which are running in automatic operation or manual operation

can be stopped by using the "Start/End" key.

h Press the "Start/End" key

The symbols for automatic or manual operation at the bottom right

of the screen are no longer visible, and the instrument returns to

the basic status.

The program end signal becomes active at the end of a program. The duration

of this signal and the relay that it operates can be defined.

v Chapter 6.9.6 "Program source"

v Chapter 7.4.6 "Program source"

key.

function key again, or press

6 Operation

Table of Contents