Table of Contents
Advertisement
6 Operation
6.2
Program design
6.2.1 General
Program
design
Process steps
H
28
Up to 99 programs can be stored in the instrument. Each program can have up
to 99 program segments which are processed sequentially.
The instrument can store a maximum of 3600 program segments.
A process step is assigned to each segment. These are normally defined by
the system manufacturer, through the setup program.
Each one of these process steps is associated with a specific state of the pro-
cess system, which has to be configured by the system manufacturer.
The user has no access to this setup, since it requires special knowledge of
the system functions and operation.
Up to 99 segments can be programmed, that include
- control functions
- controller parameter sets
- activation of setpoints for controllers and limit parameters
- setpoints
as fixed definitions.
Tip:
The comfortable way of working is to enter the process steps in
the setup program, and transfer them to the instrument afterwards.
If a few corrections are required, these can be made directly on the
instrument.
v Chapter 6.9.7 "Process step editor"
IMAGO F3000 / 10.01
Advertisement
Table of Contents
