Table of Contents
Advertisement
7 Setup Program
Where are
alarms and
messages
displayed?
5 message
types:
Priorities
System messages
are displayed like
alarms, and cannot
be configured
80
Alarms (with a red bell) and information messages (with an "i") are displayed in
the bottom line of the screen.
Alarms have a higher priority than messages, and the alarm message will only
disappear when it has been acknowledged.
Messages disappear automatically as soon as the condition that triggered the
messages no longer exists.
1.) Immediate message: just click on the message button
2.) Delayed message: click on the message button and enter the delay time
3.) Immediate alarm: just click on the alarm button
4.) Delayed alarm: click on the alarm button and enter the delay time
5.) Message turning into an alarm after a delay:
click on both the message and alarm buttons, and enter the delay.
The alarm or message shown is always the one with the highest priority.
Message text
STANDSTILL
CALIB-MODE ACTIVE
IO-BOARD NOT CALIB.
MATH ERROR1
MATH ERROR2
MATH ERROR3
MATH ERROR4
LOGIC ERROR1— 8
RESET TIME
RESTART ERROR3
Comment
Calibration mode is ON
I/O board is plugged in,
but not calibrated
Infringement of mathematical rules
triggers an alarm
e.g. division by 0
Logic module triggers an alarm
Time is not set correctly
Checksum error in the data on
restart, (for instance, after a power
interruption).
Priority
high
low
IMAGO F3000 / 10.01
Advertisement
Table of Contents
