Copying Programs - JUMO IMAGO F3000 Operating Instructions Manual

Process controller for the meat processing industry

Hide thumbs Also See for IMAGO F3000:

Table of Contents

6 Operation

6.14.4 Copying programs

Data source

Data target

The system always writes all the programs into the memory. However, it is

possible to make a selection of the programs when reading the contents out

into another instrument.

h Insert the P&P memory

h Write all the data to the P&P memory

h Remove the P&P memory and insert it into a new instrument

h Press

h Press the

h Select password entry

h Press

h Enter the password

The password in the P&P memory (source instrument) must match

the password for the configuration level of the target instrument.

key

IMAGO F3000 / 10.01

Table of Contents