Chapter 4
Configuring the reflectometry
test
Pressing the S
/S
TART
measurement. However, it is necessary to configure the measurement
and the type of results desired.
This chapter describes the different stages in configuring a reflectometry
measurement using an OTDR module, in SmartOTDR™ or OTDR
Expert.
The topics discussed in this chapter are as follows:
–
"Configuring the unit for SmartOTDR™" page 18
–
"Configuring the test in OTDR Expert" page 20
User Manual
770000102/08
TOP
key is all that is needed to start or stop a
4
17