Modifying some
parameters
before the
acquisition
In SmartOTDR™ mode, the user have access to 4 parameters he can
modified before launching the test.
To display and modify i necessary the parameters:
1
Results
page is displayed, press S
Once
The Setup page for OTDR acquisition in SmartOTDR™ mode
displays.
Fig. 10
SmartOTDR™Setup page
Laser
Fiber Number
Distance unit
Config.
The configuration file can be downloaded from the Setup page, pressing
the Load Config. menu key.
Press R
ESULTS
hard key to return to results page and launch the acqui-
sition (it can be launched directly from the
User Manual
770000102/08
Chapter 4 Configuring the reflectometry test
Configuring the unit for SmartOTDR™
The acquisition will be carried out on the
wavelength(s) selected (for multiple-wavelength
modules). In case of a multi-wavelength module,
select All to perform a measurement for all the
wavelengths available (this parameter visible
exclusively on modules with one single OTDR
port). The possible values depend on the module
used.
Modify, if necessary, the number of the fiber
using left and right direction keys.
select the unit to be used for distance (km / kfeet
/ miles / meter / feet).
This parameter displays the configuration file
selected for SmartOTDR™ acquisition, and
cannot be modified.
ETUP
hard key
Setup
page).
19