Results In Optipulses Mode - JDS Uniphase 4100 User Manual

4
Results in
Once the acquisition is completed, a screen as the following one
OptiPulses
displays:
mode
events detected
on standard trace
Fig. 41
With the OptiPulses option, the screen is as follows:
Click on one event in the results table to automatically turns the trace on
which it has been detected active
OptiPulses and SmartLink option
If the OptiPulses option is used with the SmartLink option, then the Smar-
tLink screen displays the graphical representation of the link with all the
events detected, whether they are detected on the trace with shortest
pulse or on standard trace.
User Manual
Chapter 5 Launching a reflectometry test and displaying results
Launch the acquisition pressing S
A beep is emitted at the end of the acquisition.
event detected
on trace with
shortest pulse
OTDR Traces with OptiPulses
– Two traces for each wavelength measured: the trace with
shortest pulse and the standard one,
– One single results table per wavelength with results from both
traces merged.
Example: if OTDR acquisition if performed on two wavelengths, the
screen displays 4 traces and 2 results table.
In the Summary page, the Link Table is displayed in one single line
is displayed for the wavelength.
770000102/08
OptiPulses option
/S
TART TOP key
69