Name Of A File; Save Mode - JDS Uniphase 4100 User Manual

Filenaming convention in Cable View
In Cable View, the filenaming convention is as follows:
As soon as the Cable Id changes, the result table is cleared and the next
tests are stored with the new Cable Id name.
The table view can be modified in the Setup page (see
page
Filenaming convention for Fault Finder results
If the fault finder is selected, the fault finder sor trace is using the
following filenaming convention:
Default Filename for LTS results
Press Default Filename in the LTS tab allows to apply the following
name by default for LTS results:

Name of a file

After an acquisition, and as long as the result has not been saved, the
line below
filenaming rules.
If the file has been recalled from a memory, the line below
shows its name irrespective of whether it respects the current filenaming
rules.
This name can then be modified by calling up the edit menu using the
button
name will not be modified. To return to a name made up in accordance
with the filenaming rules, simply delete the existing name.
Editing the name enables the trace to be saved in a new file (with a
new name), but it cannot rename the existing file (this function is pos-
sible in the Explorer menu). Thus the new name will not be taken into
account until the trace is saved again.
When a trace or more is displayed, in the parameter Save Mode, you can

Save mode

select three types of methods for storing traces:
User Manual
[Cable_Id]
112).
[Cable_Id][Fiber_Id][Fiber_Num]
Fiber[Cable_Id][Fiber_Num]_[Lambda]_[Direc-
tion][Pulse]
Filenaming
. If a modification is then made to the filenaming rules, the file
770000102/08
gives the name made up in accordance with the
Chapter 9 File management
File Setup menu
Figure 72 on
Filenaming
131