About Ip Video Testing; Specifying Test Settings - JDS Uniphase HST-3000 User Manual

Ip video testing

Hide thumbs Also See for HST-3000:

Table of Contents

Chapter 2 IP Video Testing

About IP Video Testing

For IP video testing, use either the Ethernet port or the DSL

port to connect to the line. Thus, there are multiple ways to

access the IP video feature: through ADSL mode, VDSL

mode, or Ethernet mode.

NOTE:

This guide is specific to IP video testing. For more informa-

tion on ADSL, VDSL, or Ethernet testing, including con-

necting to the line, see the HST-3000 ADSL Testing User's

Guide, HST-3000 ADSL2 Testing User's Guide or the

HST-3000 VDSL Testing User's Guide.

IP video testing involves the following steps:

– selecting Terminate or Monitor mode

– selecting service type (Terminate mode only)

– setting QoS thresholds

– performing the tests

Before you begin testing, make sure the test settings on the

HST-3000 match the settings of the line and network configu-

ration you are testing.

The setup procedure varies slightly, depending on the access

interface and the network configuration. Configurations can

be stored for easy recall and use (for more information, see

the HST-3000 Base Unit User's Guide).

HST-3000 IP Video Testing User's Guide

Table of Contents

Hst3000-mstv Hst3000-vmos