Table of Contents
Advertisement
Chapter 2 Starting up
Unpacking the device - Precautions
Unpacking the device - Precautions
Fitting and removing a module
Fitting a
module
8
We suggest that you keep the original packing material. It is designed for
reuse (unless it is damaged during shipping). Using the original packing
material ensures that the device is properly protected during shipping.
If another packaging is used (for returning the equipment for example),
JDSU cannot give warranty on good protection of the equipment.
If needed, you can obtain appropriate packing materials by contacting
JDSU Technical Assistance Center.
The MTS/T-BERD must be switched off, and if it is operating on
the mains, its supply cable must be unplugged.
1
Turn the instrument face down on the work surface.
2
Set the two notches on the module part (1a) into the two holes
provided for that purpose on the Base (1b).
3
Make flush the 2 connections (2a & 2b), on module and base.
4
Once positioned, fix the module to the base screwing the 2 screws
(3a) fixing the receptacle.
5
With a T-BERD/MTS 4000, repeat the process if a second small
module must be installed at the back of the platform.
User Manual
770000102/08
Advertisement
Table of Contents
