Loading An Existing Configuration File In Expertotdr - JDS Uniphase 4100 User Manual

Chapter 4 Configuring the reflectometry test
Configuring the test in OTDR Expert
Loading an
existing
configuration
file in
ExpertOTDR
34
This configuration file can be selected in SmartOTDR™ (see
the configuration file" page
To load a configuration file previously created or available in the T-BERD/
MTS and apply parameters to new OTDR Expert tests:
From the File Explorer page
1 Press F
ILE hard key
2
Select the configuration file desired
3 Load Load Config.
Press >
Press S
– ETUP hard key to display the OTDR acquisition parameters
saved in the selected configuration file.
You can modify some acquisition or file storage parameters, and save
them in a new configuration file (see
a file" on page 33).
From the Setup page
1
Select one header in either Setup page (Acquisition, Link, File...)
2 Load Config.
Press
The file Explorer page displays
3
Select the configuration file desired
4 Load Config.
Press
OTDR Expert mode.
A sound is emitted to confirm the loading.
The Setup screen is displayed again.
If the menu key Load as SMART Config. is pressed, the configura-
tion is applied for acquisition in OTDR Expert, and in SmartOTDR™
mode too.
NOTE
Some configuration files are available into the equipment, in disk/
config.
User Manual 770000102/08
18) or loaded for ExpertOTDR.
"Saving configuration parameters in
menu key.
to load the configuration file for acquisition in
"Selecting