Table of Contents
Advertisement
Fig. 47
FTTA setup
In the first screen, configure the following parameters:
Mode
Select the kind of acquisition to be performed:
Construction
Maintenance
Laser
The acquisition will be carried out on the wavelength(s) selected (for
multiple-wavelength modules). In case of a multi-wavelength module,
select All to perform a measurement for all the wavelengths available
(this parameter visible exclusively on modules with one single OTDR
port). The possible values depend on the module used.
Base Station Id
If known, enter the name of the Base Station using the edition keypad,
displayed pressing the right arrow key.
RRU Id
If known, enter the name of the RRU/RRH (Remote Radio Unit / Head)
using the edition keypad, displayed pressing the right arrow key.
User Manual
Configuring the Reflectometry test for FTTA network
FTTA OTDR Setup
Select
this
acquisition in the case of an Acceptance Testing
(see
"Acceptance Testing" on page
Select
this
acquisition in the case of Troubleshooting (see
"Troubleshooting Testing" on page
770000102/08
Chapter 6 FTTA-SLM Software option
mode
to
perform
mode
to
perform
the
OTDR
76).
the
OTDR
77).
79
Advertisement
Table of Contents
