Performing A Measurement With Smartotdr; Performing An Acquisition With Otdr Expert - JDS Uniphase 4100 User Manual

Chapter 5 Launching a reflectometry test and displaying results
Performing OTDR acquisitions
Performing a
measurement
with
SmartOTDR™
Performing an
acquisition with
OTDR Expert
40
The acquisition is carried out with the parameters saved in the Configu-
ration file. It may be stopped at any time using the
At the end of test, the results page displays.
1 Press S /S
TART
The red Test indicator goes on to show that the T-BERD/MTS is in
process of acquisition and the screen displays the trace in process
of acquisition.
2
The quality of the connection is displayed
for a few seconds (see
3
Then, a bar graph shows elapsed and remaining acquisition time.
Elapsed Number of
acquisition time averages calculated
Fig. 18
Acquisition in progress in SmartOTDR™
At the end of the acquisition, a beep is emitted, and the measurements
are displayed.
NOTE
During acquisition, the traffic on fiber is automatically detected (see
"Traffic detection" page
In this mode, the T-BERD/MTS carries out a number of averagings
defined as a function of the maximum acquisition time specified in the
Acquisition menu, and then terminates the acquisition.
User Manual 770000102/08
TOP
hard key to launch measurement.
Table 6 page
Elapsed time
39)
S /S
TART TOP
38)
Total acquisition time
key.