SmartLink view
Displaying the
details of an event
1
Click on the menu key Trace/SmartLink to select SmartLink.
A screen as the following one is displayed:
Zone 1
Zone 2
Zone 3
Fig. 51
SmartLink function
The screen is divided into three zones:
Zone 1: Graphical representation of the link, with icons symbolizing
–
the different events detected.
Zone 2: Link Table, which gives a summary of results for each
–
wavelength, with results within/without thresholds in green/red
(according to Alarm thresholds defined in the setup screen).
Zone 3: Alarms table (if any)
–
If several traces are displayed in overlay, with the same
wavelength, then only the Zone 2 is displayed, there is no
graphical representation of the link (Zone 1).
If several traces are displayed in overlay, the details of the event can be
displayed in a help window.
1
Select the event to be described on the graphic (underlined in
yellow).
2
Click on Event Diagnostic soft key
A new window, on the lower part of the screen, gives the details of
the selected event:
–
its type
–
the possible causes of the alarm
–
the thresholds applied for this event.
User Manual
770000102/08
Chapter 6 FTTA-SLM Software option
Results page
85