Table of Contents
Advertisement
Chapter 4 Configuring the reflectometry test
Configuring the test in OTDR Expert
Configuring the
file storage
parameters
30
Location B
The name of the Location B of the link may be entered here.
Operator
Use the arrow
to enter the name of the operator carrying out the
measurement.
Comment
In contrast to the other data in this menu, the comment is specific to a
fiber. This line is thus used to enter a new comment and not to display it.
The comment appears at the top of the screen, with the other parameters
of the fiber.
This comment will remain available for the next acquisition, unless it is
deleted. It is also saved when a trace is saved with a comment.
The File storage parameters must be also configured, in order to define
how the results traces will be saved onto the T-BERD/MTS.
In the Setup page, press File softkey, or press Next if one parameter is
selected in the current screen until the File Setup page displays.
Dir
This parameter cannot be configured, and display the directory selected
by default into which the file(s) will be saved (the last directory selected).
To modify the directory, go to the Explorer page and select another
directory.
Filenaming
Select Filenaming parameter and press the right arrow key to modify the
name of the file for the result trace.
In the edition keypad, enter a name manually for the file and/or use
the predefined parameters available (Cable_Id, Fiber_Num...).
Then, press Enter to validate.
User Manual
770000102/08
Advertisement
Table of Contents
