Table of Contents
Advertisement
Configuring the
Link
parameters
Bend (not available in Multimode)
With any dual or triple-wavelength measurement module, the user will
have access to the macro bend detection function in the test setup. Each
event of the selected wavelengths will then be compared.
Once parameter is selected, press Edit Number key to display the
numeric keypad and select the wished value:
None
Bend will not be detected.
Auto
Bend will be automatically detected.
Define by user
Enter the bend value (in dB), with direction keys or
numeric keypad.
In the Setup page, press Link softkey, or press Next if one parameter is
selected in the current screen until the Link Setup page displays.
The information entered in the Link Description window concerns the
editing and/or the modifications of the cable and fiber parameters. When
a trace is recalled without recall of the configuration, the parameters of
this trace will be present only in its signature.
Fiber ID and Fiber Number
1
Select the parameter Fiber Id and enter a name for the fiber, using
the edition keypad.
2
Select the parameter Fiber Number and modify the number of the
fiber to be tested.
The fiber number can be automatically incremented/decremented at
each new file save if it has been configured in the File Setup page (see
"Change Fiber Nbr" page
Cable Id
This parameter allows to enter an identification of the cable, using the
Edition menu.
Direction
The direction shows if the acquisition has been made from the origin to
the extremity (A->B) or from the extremity to the origin (B->A). Changing
direction makes it possible, when different extremities are handled, to
see the parameters of the fiber for the other extremity.
Location A
The name of the Location A of the link may be entered here.
User Manual
770000102/08
Chapter 4 Configuring the reflectometry test
Configuring the test in OTDR Expert
32).
29
Advertisement
Table of Contents
