Table of Contents
Advertisement
Chapter 7 Power meter and Source options of the OTDR Modules
Result page
Commands of the
power meter
parameters
Result page of
the Source
96
When the Powermeter function is selected, the following softkeys are
available on the results page:
The different configuration buttons are displayed:
Wavelength
Unit
Zero
On the results page, the following actions are available:
Set as Reference
Keep Result
Clear Table
If the Source function is selected (either on this Platform, on the base
Unit or on an OTDR module, or on another Platform), the Power meter
results page is different:
The Wavelength, Unit and Zero menu keys are accessible via the
–
menu key Power Config.
The Power Ref. menu key allows to reach the Standard Ref menu
–
key. It also allows to reach the Jumper Ref menu key if Power
meter function is associated with Source function onto another unit
(see
"Carrying out the reference in loopback mode" on page
Once the source icon is selected, the results page displays and the
Source can be configured.
Fig. 60
Source result page
Laser On / Laser Off Activation or shut-down of the laser (same
User Manual
770000102/08
selection of the wavelength
choice of the unit
Adjustment of the Zero value when the power
meter's optical input is closed with a plug (a
validation is required).
Selects the current result as reference value to
measure the attenuation of a link. This reference
is displayed under the measurement result until a
new reference value is chosen.
Saves the result on the corresponding line of the
table.
Deletes all the results recorded in the table.
S
TART
function as the
/S
TOP
button)
100).
Advertisement
Table of Contents
