Configuring The Unit For Smartotdr; Selecting The Configuration File - JDS Uniphase 4100 User Manual

Chapter 4 Configuring the reflectometry test

Configuring the unit for SmartOTDR™

Configuring the unit for SmartOTDR™
Selecting the
configuration
file
18
Once the SmartOTDR™ icon is validate, the
automatically.
Before any test in SmartOTDR™:
1
select the configuration file, which contains all acquisition parame-
ters and file storage setup, and which has been created in Expert
mode (see "Saving configuration parameters in a file" on page
2
the user can then configure some parameters before starting the
test
To load the configuration file to be used for SmartOTDR™ test:
1 Press F
ILE hard key.
2 Explorer
In the
media and directory into which file configuration is saved.
3
Select the file on the right list: icon
4 Load Load as SMART Config.
Press >
A beep is emitted to validate the selection of the configuration file.
Fig. 9
Load file as SmartOTDR™ Configuration
5 Press R
ESULTS
acquisition with the pre loaded configuration.
NOTE
Some configuration files are available into the equipment, in disk/
config.
User Manual 770000102/08
page, on the left of the screen, select the storage
hard key to go to results page and perform OTDR
Results
page displays
/ type: .Config.
menu keys.
33).