Configuring The Test Mode - JDS Uniphase HST-3000 User Manual

Chapter 2 Frame Relay Testing

Configuring the test mode

Configuring the test mode

10
The following procedure describes how to set the test mode.
For more information about these modes, see
modes" on page
To specify the test mode
1 Access the test configuration menus. See
test configuration menus" on page
2 Press one of the following soft keys:
– DS1
– INTERFACE (E1)
– DATACOM
– DDS
A test configuration menu appears.
3 Select Test Mode, and then select a mode for the test
operation. The following table lists the available test
modes.
Interface
T1/FT1
E1
Datacom
DDS Four-Wire
Local Loop
4 To configure other test settings, select a setting and then
specify the parameters. You can also configure settings
using the other soft keys.
5 To return to the test result display area, press the Home
navigation key.
You have specified the test mode for the HST.
HST-3000 Frame Relay Testing User's Guide
5.
Available Test Mode
Terminate, Monitor
Terminate, Monitor
DTE Emulation, DCE Emulation, Monitor
You do not have to specify a test mode
for DDS four-wire local loop test opera-
tions.
"Operating
"Accessing the
8.