Results Screen; Cable View - JDS Uniphase 4100 User Manual

Results screen

Cable view

Fig. 77
Test in progress
d
Once all tests are performed, results are displayed on both units
e If OTDR parameter is set to Auto or Manual in the Setup menu,
the OTDR acquisition starts.
If Fault Finder parameter is set to Yes and an IL or ORL value
reaches one of the user defined thresholds, the Fault Finder
starts.
See "Configuring the units" on page
Once the tests are completed, the results screen displays on both units.
If, in the Setup page, the parameter Table View is set to Cable, the
following result table is displayed:
Fig. 78
Result Cable View
User Manual 770000102/08
Chapter 8 FiberComplete Modules
111.

Results screen

119