Cli Monitoring Parameters; Parameter Tables - Proxim AP-4000 User Manual

Command Line Interface (CLI)

CLI Monitoring Parameters

Configure a Security Profile with 802.11i Security Mode
[Device-Name]>set secprofiletbl <index> secmode 802.11i rekeyint <value> status enable
Example:
[Device-Name]>set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable
Configure a Security Profile with 802.11i-PSK Security Mode
[Device-Name]>set secprofiletbl <index> secmode 802.11i-psk passphrase <value> status
enable
Example:
[Device-Name]>set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable
CLI Monitoring Parameters
Using the show command with the following table parameters will display operating statistics for the AP (these are the
same statistics that are described in the
• staticmp: Displays the ICMP statistics.
• statarptbl: Displays the IP ARP Table statistics.
• statbridgetbl: Displays the Learn Table.
• statiapp: Displays the IAPP statistics.
• statradius: Displays the RADIUS Authentication statistics.
• statif: Displays information and statistics about the Ethernet and wireless interfaces.
• stat802.11: Displays additional statistics for the wireless interfaces.
• statethernet: Displays additional statistics for the Ethernet interface.
• statmss: Displays station statistics and Wireless Distribution System links.
• statmesh: Displays statistics about the Mesh network.

Parameter Tables

Objects contain groups that contain both parameters and parameter tables. Use the following Tables to configure the
Access Point. Columns used on the tables include:
• Name - Parameter, Group, or Table Name
• Type - Data type
• Value - Value range, and default value, if any
• Access = access type, R = Read Only (show), RW = Read-Write (can be "set"), W = Write Only
• CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
• System Parameters
– Inventory Management Information
• Network Parameters
– IP Configuration Parameters
— DNS Client for RADIUS Name Resolution
– DHCP Server Parameters
– SNTP Parameters
Monitoring
- Access Point system information
- Hardware, firmware, and software version information
- IP and Network Settings
- Configure the Access Point's IP settings
- Enable or disable dynamic host configuration
- Configure
section).
- Configure the Access Point as a DNS client
AP-4000 Series User Guide
184