Command Line Interface (CLI)
Parameter Tables
•
statiapp: Displays the IAPP statistics.
•
statradius: Displays the RADIUS Authentication statistics.
•
statif: Displays information and statistics about the Ethernet and wireless interfaces.
•
stat802.11: Displays additional statistics for the wireless interfaces.
•
statethernet: Displays additional statistics for the Ethernet interface.
•
statmss: Displays station statistics and Wireless Distribution System links.
Parameter Tables
Objects contain groups that contain both parameters and parameter tables. Use the following Tables to configure the
Access Point. Columns used on the tables include:
•
Name - Parameter, Group, or Table Name
•
Type - Data type
•
Value - Value range, and default value, if any
•
Access = access type, R = Read Only (show), RW = Read-Write (can be "set"), W = Write Only
•
CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
•
System Parameters
–
Inventory Management Information
•
Network Parameters
–
IP Configuration Parameters
—
DNS Client for RADIUS Name Resolution
–
DHCP Server Parameters
–
SNTP Parameters
–
Link Integrity Parameters
•
Interface Parameters
–
Wireless Interface Parameters
—
Channel Blacklist Parameters
—
Wireless Distribution System (WDS) Parameters
–
Wireless Interface SSID/VLAN/Profile Parameters
SSIDs are supported; different security settings can be applied to each SSID, and a unique VLAN can be
configured per SSID.
–
Ethernet Interface Parameters
•
Management Parameters
–
SNMP Parameters
–
HTTP Parameters
certificate passphrase.
–
Telnet Parameters
–
Serial Port Parameters
–
RADIUS Based Management Access Parameters
Telnet access.
–
SSH Parameters
–
TFTP Server Parameters
- Access Point system information
- Hardware, firmware, and software version information
- IP and Network Settings
- Configure the Access Point's IP settings
- Enable or disable dynamic host configuration
- Configure
- Monitor link status
- Configure Wireless and Ethernet settings
- View and configure blacklisted channels
- Set the speed and duplex of the Ethernet port.
- Control access to the AP's management interfaces
- Set read and read/write passwords
- Set up the graphical web browser interface. If required, enable SSL and configure the SSL
- Telnet Port setup
- Serial Port setup
- Enable SSH and configure the host key.
- Set up for file transfers; specify IP Address, file name, and file type
- Configure the Access Point as a DNS client
- Configure the WDS partnerships
- Configure the SSIDs, VLANs, and security modes. Up to 16
- Configure RADIUS Based Management Access for HTTP and
AP-700 User Guide
174