Using the Command Line Interface
Parameter Tables
Objects contain groups that contain both parameters and parameter tables.
Use the following Tables to configure the Access Point. The Access Point CLI is under development as this document
is being prepared; therefore, some table cells are blank where a feature has not yet been implemented or information
needs validation. Columns used on the tables include:
— Name - Parameter, Group, or Table Name
— Type - Data type
— Values - Value range, and default value, if any
— ACC. - Indicates access type. R = Read Only (show), RW = Read-Write, can be "set", W = Write Only
— CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated
parameters are described in the following Parameter Tables:
•
System Parameters
•
Miscellaneous System Parameters
•
Inventory Management Information
•
Network Parameters
•
DHCP Server Parameters
•
DNS Parameters
•
VLAN Parameters
•
Interface Parameters
•
Wireless 802.11b Parameters
•
Wireless 802.11a Parameters
•
Ethernet Interface Parameters
•
Management Parameters
•
SNMP Parameters
•
SNMP Table Host Table Parameters
•
Telnet Parameters
•
Serial Port Parameters
•
HTTP (web browser) Parameters
•
TFTP Server Parameters
•
NTP Parameters
•
Security Parameters
•
RADIUS Server Parameters
•
Encryption Parameters
•
VPN
•
AAA Parameters
- Configure Authentication, Authorization and Accounting (AAA) settings
•
Basic AAA Parameters
•
AAA External Authorization Parameters
•
AAA Internal Authorization Parameters
•
Logging Parameters
•
URL Filtering Parameters
•
URL Filtering IP Table
•
URL Filtering DNS Table
•
ICC (Information Control Console) Parameters
•
ICC Button Configuration
•
ICC Banner Configuration
•
SMTP Parameters
- Enable redirection of outgoing e-mails
- Access Point system information
- IP, DHCP, DNS and VLAN configuration
- Wireless and Ethernet configuration
(including WDS)
- Control access to the AP-2500's management interfaces and set the time
- Access Point security settings and RADIUS configuration
- System and AAA Logging
- Prevent subscribers from accessing specified Web sites
- Configure the Information and Control Console
205