MOVING THE UNIT
Moving the unit
NOTE: After road travel, remove all road safety devices before carrying out any job site travel.
1. Make sure that the engine accelerator lever (2) is in
low idle position.
2. Make sure the stabilizers are completely raised.
3. Make sure the doors are properly closed and the en-
gine tilt hood is closed and locked.
4. Adjust the operator's seat correctly.
5. Fasten the seat belt (3) correctly and then adjust it.
6. Check that the direction of travel lever (4) is in neutral
position.
7. Start the engine. Raise the loader attachment about
20 cm (7.9 in) off the ground.
4 - OPERATING INSTRUCTIONS
4-9
1
PTIL12TLB0430AB
2
PTIL12TLB0104AB
3
PTIL12TLB0105AB