Stabilizer Wear Pads Adjust - Case 570T Operator's Manual

EVERY 250 HOURS

Stabilizer wear pads adjust

Your machine is fitted with stabilizer sleeve locking with
plastic pad arrangement to provide comfort to the operator
during backhoe operation by reducing the play between
sleeve & vertical outer.
When machine is in operation there is a defined clearance
between vertical outer & inner sleeve.
This gap increases as the machine continues to operate.
This dangling of the machine can be controlled by plastic
pads provided inside the H-frame which pushes against the
inner sleeve to maintain minimum clearance between the
vertical outer resulting minimum play.
As the inner sleeve comes out of the vertical outer during
backhoe operation every time it wears out plastic pad re-
sulting in building of clearance & subsequent dangling of
the machine. The pads must be replaced if found worn out
or damaged.
1. Unscrew the 4 numbers M10 bolts (1) along with con-
ical washers (2) & take out cover sleeve locking (3)
along with shims (4).
2. Insert cover sleeve locking (3) along X-direction only
behind the pad (5) from outside & press firmly with
hand.
7 - MAINTENANCE
7-37
1
PTIL12TLB0483AB
2
PTIL12TLB0486AB