Engine Oil And Oil Filter – Change - Case 570T Operator's Manual

EVERY 500 HOURS
Engine oil and oil filter – Change
1. Follow Machine safety position (Refer Engine - Safety
rules)
2. Open and raise the engine tilt hood.
3. Place a container with suitable capacity under the en-
gine.
4. Remove the cap of the filler neck.
5. Remove the engine crankcase drain valve.
NOTE: Drain the engine oil when it is still hot. The oil will
flow more easily.
6. Now wait for the oil to completely flow out of the engine.
7. Tighten the drain plug. Torque: 95 N·m (70 lb ft).
8. Unscrew and remove the cartridge (1).
9. Apply a thin layer of clean oil on the seal of the new
cartridge.
NOTE: Do not fill the new filter with oil before installing it.
10. Assemble the new cartridge (1).
11. Manually screw in the cartridge until the seal touches
the support (2).
12. Tighten it further by 3/4 of a turn.
NOTE: Over tightening can damage the filter seal. Do not
use non genuine spare parts. Engine may get damaged by
using a non genuine filter and non approved oil.
7 - MAINTENANCE
7-39
1
PTIL12TLB0228BB