Engine Coolant - Replace - Case 570T Operator's Manual

Engine coolant - Replace

1. Follow Machine safety position. (Refer Engine - Safety
rules)
2. Place a container with sufficient capacity under the ra-
diator drain cock.
3. Unscrew and remove the cap (2) from the radiator (1).
CAUTION
Burn hazard!
Hot coolant can spray out if you remove the
filler cap while the system is hot. After the sys-
tem has cooled, turn the filler cap to the first
notch and wait for all pressure to release be-
fore proceeding.
Failure to comply could result in minor or mod-
erate injury.
4. Install a drain pipe on the drain cock (3) and put the
other end into a container.
5. Open the radiator drain cock (3) and drain the coolant.
6. After the system is completely drained, close the drain
cock (3).
7. Rinse the system with fresh water, drain again and then
fill the system
NOTE: if you use a detergent solution for rinsing, follow
the instructions for preparing the solution. After draining
the detergent solution, rinse again with fresh water.
8. Check the condition of the hoses, connections and the
water pump.
9. Make sure that the external surfaces of the engine and
the radiator are clean.
7 - MAINTENANCE
C0043A
7-55
1
PTIL14TLB0042AA
2
PTIL12TLB0446AB