Front Axle Hub Oil (4Wd Only) - Replace - Case 570T Operator's Manual

Front axle hub oil (4WD Only) - Replace

1. Follow Machine safety position. (Refer Engine - Safety
rules)
2. Slightly raise the front part of the machine by means
of the loader attachment, until the front wheels are no
longer in contact with the ground.
3. Place a suitable support under the front axle.
4. Manually position the wheel until the hole of the plug
(1) is at the bottom.
5. Unscrew and remove the plug (1).
6. Drain the oil completely.
7. Manually position the wheel to horizontal position.
8. Fill the oil until the level reaches the plug hole.
9. Retighten the plug (1). Torque: 80 N·m (59 lb ft).
10. Repeat for the other reduction gear as well.
11. Lower the machine to the ground.
7 - MAINTENANCE
7-47
1
PTIL12TLB0215AB