Loader Attachment Safety Strut - Case 570T Operator's Manual

Loader attachment safety strut

Located on the left-hand side of the loader attachment,
this safety strut enables the loader attachment to be
locked in the raised position for maintenance or servicing
the unit.
Locked position
1. Completely raise the loader attachment.
2. Stop the engine and remove the starter switch key.
3. Remove the split pin (1) and the lock pin (2).
4. Place the strut (3) on the cylinder rod and install the
pin (2) and the split pin (1) back into the holes in the
strut.
NOTICE: It is mandatory to install the safety strut when
carrying out any operation requiring the loader attach-
ment to be in the raised position.
5. Lower the loader attachment until the safety strut is
firmly against the cylinder.
Unlocked position
1. Completely raise the loader attachment and stop the
engine.
2. Remove the split pin (1) and the lock pin (2).
3. Remove the strut (3) from the attachment and install
the pin (1) and the split pin (2) back into the holes in
the strut.
4. Start the engine and lower the loader attachment.
6 - WORKING OPERATIONS
6-11
1
PTIL12TLB0534AB
2
PTIL12TLB0535AB
3
PTIL12TLB0536AB