Fuel Filter - Change - Case 570T Operator's Manual

Fuel filter - Change

1. Follow machine safety position. (Refer Engine - Safety
rules)
2. Open and raise the engine tilt hood.
3. Clean the filter assembly externally.
4. Loosen the bleed screw (2).
5. Unscrew the fuel filters (1) and discard.
6. Clean the filter mounting surface.
7. Apply a thin film of clean oil on the new oil filter sealing
ring (2) and install the filter.
8. Turn until the sealing ring contacts the mounting sur-
face, then tighten an additional 3/4 to 1 full turn.
9. Do not over tighten.
10. With the bleed screw loose, prime the fuel system with
the help of priming pump.
11. Start the engine and ensure no fuel is leaking.
NOTE: Do not use non genuine spare parts. Injection
pump may get damaged by using a non genuine filter.
7 - MAINTENANCE
7-42
1
PTIL12TLB0445AB
2
PTIL12TLB0231AB