Moving The Unit; Machine Travel - Case CX145C SR Operator's Manual

MOVING THE UNIT

Machine travel

WARNING
Controls can be reversed!
In the normal travel position, the operator's
compartment is above the idler wheels and the
travel reduction gears are to the rear of the up-
per structure. If the upper structure is turned
180 degrees in relation to the undercarriage,
the controls are reversed.
Failure to comply could result in death or se-
rious injury.
ATTENTION: Before undertaking any travel, raise the at-
tachment and the dozer blade (if equipped).
NOTE: Travel speed depends on the tilting angle of the
travel control levers and pedals and the speed travel
mode selected.
NOTE: The different travel configurations described here-
after are with the travel reduction gears to the rear of the
upperstructure.
Travel alarm
The travel alarm sounds continuously or for 10 seconds,
depending the position of the switch. (Refer to page 3-58).
Straight line travel (forward travel)
Press the two pedals (or push the two levers) forward at
the same time or press the pedal located on the right.
4 - OPERATING INSTRUCTIONS
W0289A
4-15
1
71DCD62A
2
CS98M546Z