Starting The Engine - Case 570T Operator's Manual

STARTING THE UNIT

Starting the engine

1. Check that the seat (1) is properly locked in the loader
attachment working position.
2. Adjust the seat and fasten the seat belt.
3. Check that the parking brake lever (2) is in raised po-
sition.
4. Check that the engine accelerator lever is in idle posi-
tion.
5. Check that the direction-of-travel lever (3) is in neutral
position.
6. Check that the gearshift lever (4) is in neutral position.
Turn the starter switch key to the "ON" position. Only bat-
tery lamp (8), engine oil pressure warning lamp (5), and
cold start indicator (9) will remain on along with gauges
(6) and (7) set to position. Press the accelerator pedal
down about a quarter of the way. Wait till the cold start
indicator (9) goes off and then turn the key to the starting
position. Release the key as soon as the engine starts.
If the engine fails to start, turn the starter switch key to
"OFF" position and wait about 1 min before starting the
operation again.
After starting the engine run it at low idle for at least 1 min
to ensure lubrication to turbo charger.
NOTICE: Do not operate the starter motor for more than
20 s at a time. Do not operate the starter motor when the
engine is running.
When the engine is running, check the indicators and in-
dicator lamps to make sure that all systems are operating
correctly. Using the accelerator pedal, run the engine at
half speed until it has reached normal operating temper-
ature.
4 - OPERATING INSTRUCTIONS
4-5
1
PTIL14TLB0056BB
2
PTIL14TLB0005AB